A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
Transmission Cooler: Service and Repair
5 Speed A/T 01V
ATF lines and ATF cooler, cleaning
Special tools and equipment
^
VAG1306 drip tray
^
Hose, approximately 18 mm
^
Compressed air gun, standard
^
Protective glasses
Notes
^
Always blow compressed air through oil cooler and ATF lines (max. 10 mbar) before installing a replacement transmission.
^
When installing ATF lines, insert into transmission or cooler by hand until impact first and then tighten bolts.
WARNING: Wear protective glasses.
-
Place VAG1306 drip tray underneath.
-
Remove bolt -2-.
-
Disconnect ATF lines from transmission.
-
Slide a hose with approximately 18 mm diameter onto ATF line -A- and secure with hose clamp. Place the other end of the hose into an
appropriate container.
-
Blow through ATF line -B- with compressed air gun.
-
Change hose from ATF line -A- to ATF line -B- and repeat procedure.
-
Re-secure ATF lines.
-
Then check ATF level and top off.