A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
/Page-3166002.png)
-
Using 3287 ejection device for steering rod, press track rod off wheel bearing housing.
-
Remove bolts mounting brake caliper to wheel bearing housing.
-
Remove brake caliper and hang from body.
CAUTION:
-
Do not allow caliper to hang by brake hose. The unsupported weight can stretch and damage the hose
-
Do not loosen brake hose or lines.
-
Remove brake disc.
-
Mark installation position of eccentric washer for bolt (arrow -2-) for wheel bearing housing to lower control arm and remove.
-
Remove wheel bearing housing to upper control arm bolt (arrow -1-).
-
Remove wheel bearing housing from drive axle and remove.
Installing
-
Install in reverse order of removal.
CAUTION:
Some fasteners are designed to be used only once and are unreliable and may fail if used a second time. This includes, but is not
limited to, nuts, bolts, washers, circlips and coffer pins. Always follow recommendations in this repair information, replace these
