A4 Quattro Sedan L4-1.8L Turbo (AWM) (2001)
Speedometer Gear, M/T: Service and Repair
5 Speed Manual Transmission 01A All Wheel Drive
Speedometer drive gear, removing and installing
Special tools and equipment
-
VW195 arbor
-
VW295 needle bearing drift
-
VW681 extractor lever
-
VAG1306 drip tray
Removing
-
Remove left drive flange and seal -B- = drive flange seal, replacing.
-
Remove speedometer vehicle speed sensor, Refer to Sensors and Switches-MT, Service and Repair.
-
Press retaining clips in direction of arrows using screwdriver.
-
Carefully remove drive gear by prying out, alternating between sides.
Installing
Installation is the reverse of removal.
CAUTIONS: Install the drive gear carefully onto the differential, without canting. Do not use force, the drive gear can break easily
Installation position: