A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
Trim Panel: Service and Repair
Rear Lid Trim
Luggage Compartment Trim
Rear Lid Trim
Special tools, testers and auxiliary items required
‹› Pry lever (80 - 200)
Removing
-
Remove the warning triangle bracket. Refer to => [ Warning Triangle Bracket ]. See: Warning Triangle Bracket
-
Remove rear lid lock. Refer to => [ Rear Lid Lock Trim ]. See: Rear Lid Lock Trim
-
Unclip the stop rails using a screwdriver.
-
Remove the bolt - 2 -.
-
Pry the rear lid trim - 1 - out using a pry lever (80 - 200) - arrows -.
-
Disengage the rear lid trim at the hinges and remove it.
Installation
Installation is performed in reverse order of removal, noting the following:
‹› If the trim clamps remain in the rear lid mounting points, remove them and insert them in the trim.
‹› Check clamps for damage or deformation, replace if necessary.
-
Position the rear lid trim and press it on until it engages audibly.
Tightening specifications, refer to => [ Rear Lid Trim Assembly Overview ] See: Service and Repair/Removal and Replacement/Luggage