A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
/Page-1489002.png)
Display on vehicle diagnostic, test and information system :
‹› The request to enter a display group number appears in display field - 1 -.
‹› An entry keypad is shown in display field - 2 -.
-
Using the entry keypad, enter in display field - 2 - the " 007" for the display group number and confirm by pressing the " Q button". (Reset
pistons).
-
To exit the entry template, press the green Arrow button at the lower left.
-
Switch off ignition
-
Insert brake pedal actuator (V.A.G 1869/2 ) between the brake pedal and driver seat by pressing the brake pedal down at least 60 mm. By doing
this, the valves in the brake master cylinder are closed and the brake fluid reservoir does not run empty.
-
Raise vehicle.
-
Remove wheels.
-
Connect hose from a bleeder bottle to one of the bleeder screws on the rear caliper.
-
Open a bleeder screw on the rear brake caliper to reduce the pressure from the brake system.
-
Close the bleeder screw.
‹› Do not remove brake pedal loading device (V.A.G 1869/2 ).
-
Disconnect parking brake connector.
