A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
Position motor bolts by hand and screw in a few turns. If threads are damaged, entire brake caliper must be replaced!
-
Tighten motor bolts. Tightening specification, 12 Nm
-
Connect connector to the motor.
‹› Only insert connector by hand to avoid damaging it.
‹› Ensure connectors on vehicle side and actuator side are free of dirt and damage.
-
Install motor in the bracket.
-
Install wheels.
After replacing actuator, basic setting 006 must be performed with the vehicle diagnostic tester in the EPB function.
-
Connect vehicle diagnosis, testing and information system (VAS 5051B) or (VAS 5052) to the 16-pin Data Link Connector (DLC) in the vehicle
with ignition switched off.