A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
/Page-728003.png)
-
Install Engaging Device (VAS 5161/6) with the Installation Fork (VAS 5161/5) in the outer threads of the Guide Plate for FSI Engine (VAS
5161/19B ).
-
Press the Installation Cartridge (VAS 5161/8) down while rotating its knurled bolt to the right until the points engage in the valve keepers.
-
Move the knurled wheel back and forth slightly. This presses the valve keepers apart and captures them in the installation cartridge.
-
Release the Pressure Fork (VAS 5161/2).
-
Remove the Installation Cartridge (VAS 5161/8 ).
-
Remove valve stem seals using Valve Seal Removal Tool (3364).
-
If the Valve Seal Removal Tool (3364) cannot be used because there is not enough space, drive the roll pin - arrow - out using a drift and remove
the impact attachment.
