A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
/Page-2140003.png)
-
Insert the shaft - D - of the control motor- B - into the cam plate - E -.
‹› The control motor does not have a stop; therefore the control motor shaft can be inserted into the cam plate - E - at any position.
-
Install the screws - C -.
-
Connect the connector - D -.
-
Install the wiring harness so that it cannot come in contact with any moving parts (e.g. the actuating arm).
-
Install the removed parts in the opposite order.
-
Perform a basic setting and the output Diagnostic Test Mode (DTM) on the A/C system. Refer to Vehicle Diagnosis, Testing and Information
System VAS 5051 in "Guided Fault Finding" function.
‹› On this vehicle, the control motors are equipped with electronics, during the first basic setting, a new control motor learns its position on the air
conditioner and can then be controlled by the A/C Control Head Climatronic Control Module (J255) currently all control motors are identical.
Vehicle Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.
‹› During the basic adjustment, the control motors are assigned and adapted corresponding to the switching sequence of the wiring. If this sequence
does not conform the specification, the control motors will adapt incorrectly and the door control will be wrong. Refer to => [ Climatronic Control
Module ] See: Description and Operation/A/C System Control.
-
Check the A/C control head Climatronic Control Module (J255) DTC memory and erase any displayed malfunction if necessary. Refer to Vehicle
Diagnosis, Testing and Information System VAS 5051 in "Guided Fault Finding" function.
