A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
8
Bolt, 10 Nm
9
Bolt, 200 Nm +180°
‹› Replace after each removal. Refer to => [ Drive Axle General Information ] See: Transmission and Drivetrain/Drive Axles, Bearings and
Joints/Service and Repair/Front Suspension.
‹› Before installing, clean the threads in the constant velocity joint with a tap.
10
Wheel Hub
‹› Ejecting and pressing in, refer to => [ Wheel Bearing Unit ] See: Overhaul/Front Suspension.
11
Wheel bearing
‹› Ejecting and pressing in, refer to => [ Wheel Bearing Unit ] See: Overhaul/Front Suspension.
CAUTION!
‹› Avoid contaminating with dirt and damaging the seal when setting down/storing => [ Avoid contaminating with dirt and damaging
the seal when setting down/storing. ].
12
Bolt, 40 Nm
‹› Always replace after removal.
13
Nut
‹› Always replace after removal.
‹› Pay attention to the different nut versions and to the tightening specifications.
‹› After loosening threaded connection of guide control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
14
Control Arm
15
Nut
‹› Always replace after removal.
‹› Pay attention to the different nut versions and to the tightening specifications.
‹› After loosening threaded connection of track control arm to wheel bearing housing, adhesive residue must be removed on thread of linkage
stub.
16
Guide Link
17
Tie Rod End
18
Nut
‹› Pay attention to the different nut versions and to the tightening specifications.
‹› Always replace after removal.
19
Bolt, 9 Nm
20
Wheel Speed Sensor
21
Drive Axle
22
Bolt, 70 Nm
‹› Always replace after removal.