A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
/Page-610003.png)
-
Install the drive axle. Refer to => [ Drive Axle ] See: Transmission and Drivetrain/Drive Axles, Bearings and Joints/Axle Shaft Assembly/Service
and Repair/Removal and Replacement/Front Suspension/Drive Axle.
-
Tighten wheel.
-
On vehicles with automatic headlamp range control system, perform basic setting of headlamps. Refer to => [ Headlamps ] See: Lighting and
Horns/Headlamp/Adjustments
-
If the vehicle level sensor was removed and installed on a vehicle with electronically controlled damping or if the linkage was loosened, the
control position must be reprogrammed. Refer to => [ Control Position, Programing with VAS 5051B ] See: Steering and
Suspension/Suspension/Suspension Control ( Automatic - Electronic )/Testing and Inspection..
-
If the control position was reprogrammed on vehicles with lane assist, the directional stabilization assistance control module ( J759) must be
re-calibrated. Refer to => [ Lane Assist Calibration Procedure ] See: Alignment/Service and Repair/Procedures/Lane Assist Calibration Procedure.
