A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
/Page-973012.png)
-
Insert the vehicle-specific single wire end from the front into the pliers jaws as far as the stop and squeeze the pliers together completely.
-
Open pliers again and remove the stripped wire end.
-
Twist bare strands one-half turn.
-
Repeat the procedure on the other end of the vehicle-specific individual wire.
-
Adjust the sliding stop in the Wire Stripper ( VAS 1978/3) pliers jaws to 6 to 7 mm for the wire to be stripped.
-
Insert the yellow repair wire end from the front into the pliers jaws as far as the stop and squeeze the pliers together completely.
-
Open pliers again and remove the stripped wire end.
-
Repeat this procedure on the other repair wire end.
-
For the repair of a 0.25 mm 2 wire, use a small yellow crimp connector from the Wiring Harness Repair Set (VAS 1978A ).
-
To press the crimp connector, use the Crimping Pliers (Base Tool) (VAS 1978/1-2) from the Wiring Harness Repair Set (VAS 1978A) with the
Exchangeable Head, 0.35 mm-2.5 mm (VAS 1978/1-1).
