A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
‹› Studs in bracket are preset. If necessary, correct adjustment.
-
Place sensor on a soft and clean surface.
Measure dimension - a - of all studs.
Dimension - a - must be 43 mm.
-
Insert bracket and tighten bolts.
Torque specification, refer to => [ Adaptive Cruise Control Sensor Assembly Overview ] See: Maintenance/Alignment/Service and
Repair/Procedures/Adaptive Cruise Control Sensor Assembly Overview
-
Install the adaptive cruise control sensor (G550 ) and carefully push the nuts by hand onto the threaded pins in the sensor.
-
Install the air intake grille.
-
Calibrate the adaptive cruise control. Refer to => [ Adjustment Procedure with ACC Setting Device VAS 6190 ] See:
Maintenance/Alignment/Service and Repair/Procedures/Adjustment Procedure with ACC Setting Device VAS 6190.