A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
Suspension Control Module: Service and Repair
Level Control System Control Module
Level Control System Control Module
Special tools, testers and auxiliary items required
‹› Torque Wrench (V.A.G 1783)
Removing
The active steering control module (J792) is located in the footwell under the driver seat.
Before removing control module, read out code using Guided Fault Finding in "Replace control module" function.
-
Loosen the driver seat and slide it back with the wires connected.
-
Remove the sill panel strip.
-
Remove the foot rest..
-
Disengage the carpet and support it using a suitable wood block - 6 -.
-
On RHD vehicles, remove the E-box for the telephone transceiver (R36) and move it to the side.
-
Remove nuts - 7 -.
-
Remove the nuts - 1 - and remove the ground wire - 2 - from the threaded pin.
-
Carefully disconnect the wiring harness clip connection - 3 - from the bracket - 4 -.
-
Remove the wiring harness connectors - 3 - from the control module - 8 -.
-
Remove the bolts - 5 - from the control module - 8 - and remove the bracket - 4 -.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so:
Follow the sequence when installing the control module:
-
Tighten the bracket - 4 - with the bolts - 5 - to the control module - 8 - to 8 Nm.