A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
-
Press linkage stub of guide control arm off conical seating using (T40010 A).
-
Remove the bolt - 1 -.
-
Remove booth joint pins in the upper control arm - 2 - from the wheel bearing housing.
The slits in the wheel bearing housing must not be widened using a chisel or similar tool!
-
Loosen the wheel bearing housing from the drive axle splines and remove it.
‹› The drive axle must not hang down, otherwise the inner joint will be damaged by overflexing.
‹› Secure drive axle to body using wire.
Installing
Installation is performed in the reverse order of removal. Observe the following when doing so: