A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
‹› When mounting the wheel bearing housing onto the sleeve (T40184/1) be careful not to damage or push the rubber grommet on the rear rubber
bonded bushing.
1. (VW 411)
2. (T40184/2)
3. Wheel Bearing Housing
4. (T40184/1). The side with the groove must face the wheel bearing housing. On a bonded rubber bushing with a "positioning tab", this is in the
groove on the (T40184/1).
-
Press out the front rubber bonded bushing.
Install the front rubber bonded bushing
-
Install the front rubber bonded bushing into the sleeve (T40184/3). The "thin" collar - arrow - must face upward.
In order to install the front rubber bonded bushing, the ( T40184/2) - 3 - must be mounted on the front rubber bonded bushing in such a way so that the
lugs - 2 - fit into the grooves - 4 -.