A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
Shift Cable: Removal and Replacement
Selector Lever Boot, Separating from Handle
Selector Lever Boot, Separating from Handle
Removing
-
Remove selector lever handle. Refer to => [ Selector Lever Handle ] See: Shifter A/T/Service and Repair/Removal and Replacement/Selector
Lever Handle.
-
Bind together the spring tabs - 1 - on the selector lever handle using a cable tie - 3 - as shown in the illustration.
-
Slide selector lever boot sleeve - 2 - over the retaining tabs on the spring tabs - arrow -.
-
Remove cable tie and the sleeve with the selector lever boot from the selector lever.
Installing
Install in reverse order, paying attention to the following:
Installation position of selector lever boot:
‹› The longer side of the frame for selector lever boot faces toward the driver side.
-
Install selector lever handle. Refer to => [ Selector Lever Handle ] See: Shifter A/T/Service and Repair/Removal and Replacement/Selector Lever
Handle.