A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
-
When tightening the drive pinion, the counterhold tool (3028) must be supported on the housing brace - arrow -.
- A - 3 bolts M 8 x 25
- B - 32 mm socket
- C - toggle
CAUTION!
Increase tightening torque gradually, frequently measuring friction torque. The friction torque measured prior to removal must not be
exceeded! Otherwise the rear final drive must be replaced!
-
Tighten the new drive pinion nut just enough until the measured friction torque is reached before removing.
-
Install rear final drive, refer to => [ Rear Final Drive ] See: Service and Repair/Rear Final Drive 0BC (0B4A,0B2A,0B6A,0B5A
Transmission)/Rear Final Drive.
-
Checking axle oil in rear final drive, refer to => [ Gear Oil in Rear Final Drive, Checking ] See: Fluid - Differential/Service and Repair/Rear Final
Drive 0BD (0B2A,0B6A,0B4A,0B5A Transmission).
Flange/Driveshaft Seal
Special tools, testers and auxiliary items required
‹› Pressure plate (VW 402)