A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
/Page-1345001.png)
Constant Velocity Joint: Overhaul
Outer CV Joint with 88 mm, 100 mm or 108 mm Diameter
Outer CV Joint with 88 mm, 100 mm or 108 mm Diameter
Outer CV Joint, Removing
-
Secure drive axle with protective covers in vise clamp.
-
Open both clamping sleeves and remove protective joint boot from outer joint.
-
Strike a copper or brass drift - A - on CV joint inner race with a hammer.
-
Remove joint and protective joint boot.
Outer CV Joint, Installing
Joints and protective joint boots must be free of grease.
-
Replace the circlip - 1 -.
-
Slide on the small clamp with the protective boot and position the protective boot on the drive axle according to the version.
Version with Identification Groove:
-
Position CV boot in outer groove - arrow B -.
