A4 Quattro Sedan L4-2.0L Turbo (CAEB) (2009)
Wheel Bearing: Removal and Replacement
All Wheel Drive
All Wheel Drive
Wheel Bearing Housing, Wheel Bearing Unit and Coil Spring Shock Absorber, Assembly Overview
1
Drive Axle
2
Backing Plate
3
Bolt
‹› Torque specification, refer to => [ Drive Axle with 88 mm Outer CV Joint and 100 mm Inner CV Joint, Assembly
Overview ] See: Axle Shaft Assembly/Service and Repair/Removal and Replacement/Rear Suspension/Drive Axle with 88 mm Outer CV Joint and 100
mm Inner CV Joint, Assembly Overview or => [ Drive Axle with 100 mm Outer CV Joint and 108 mm Inner CV Joint, Assembly
Overview ] See: Axle Shaft Assembly/Service and Repair/Removal and Replacement/Rear Suspension/Drive Axle with 100 mm Outer CV Joint and 108
mm Inner CV Joint, Assembly Overview.
4
Upper Control Arm
5
Nut, 95 Nm
‹› Always replace after removal.
‹› Must be tightened in the curb weight position. Refer to => [ Wheel Bearing, with Coil Spring, Lifting to Curb Weight Position ] See:
Procedures/Rear Suspension.
6
Eccentric Washer