A4 Quattro Sedan V6-2.8L (ACK) (1997)
Front Bumper: Service and Repair
Front Bumper, Removing And Installing
1
-
Combination bolt
-
23 Nm (17 ft lb)
2
-
Hex bolt
-
45 Nm (33 ft lb)
-
Impact absorber is secured on right longmember with 4 hex bolts
3
-
Impact absorber
-
To remove, remove hex bolts and pull impact absorber out front.
4
-
Bracket
-
Removing and installing See Fig. 2
5
-
Bumper
-
To remove, remove Torx(R) screws at wheel housing liner.
-
Remove air inlet grill at bumper.
-
Remove combination bolts -1-.
-
When installing, tighten to 23 Nm (17 ft lb).
-
Unclip bumper from bracket -4- in direction of arrow and pull off towards front.
6
-
Spoiler
-
Removing and installing. See: Front Bumper Spoiler, Removing And Installing
7
-
Torx(R) screw
-
1 Nm (9 in. lb)
Fig. 1 Bumper Height Adjustment