A4 Quattro Sedan V6-2.8L (ACK) (1997)
Exterior Moulding / Trim: Service and Repair
Roof Trim Molding, Removing And Installing
-
Removing side window.
-
B-pillar trim, removing and installing. See: Lock Carrier/Service and Repair
-
Remove door seals in area of roof trim molding.
Removing
-
Pry cover strip -2- off root trim molding -1-.
-
Drill off rivets -3- and remove roof trim molding -1-.
Installing
A -
0.7 + 0.5 mm
B -
3 + 0.5 mm
C -
1.5 + 0.5 mm
These dimensions must be strictly observed.
-
Rivet roof trim molding -1- at arrows first (for centering).
-
From there, rivet tight towards front and rear.
-
Use special tool VAG1617 B to install rivets.
NOTE: If paint is damaged while drilling off a rivet, this should be repaired immediately. If necessary anti-corrosion measures should be taken
-
Snap cover strip -2- on from front to back.