A4 Quattro Sedan V6-2.8L (ACK) (1997)
Power Seat Switch: Service and Repair
WARNING!
Before starting work on seats, connect VAS5094 airbag adapter. See: Tools and Equipment/Electrical / Mechanical Repair
CAUTION!
Only the switch circuit board can be removed. The switches in the side seat trim cannot be replaced separately.
NOTE: The switch unit circuit board is ins tailed in the side seat trim on door sill side.
1
-
Plastic cover
2
-
Bolts (4x)
3
-
Switch unit circuit board with wiring harness
Removing:
-
Move seat to bottom-most position.
-
Remove seat. See: Service and Repair
-
Remove door sill side seat trim. See: Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service and Repair/Procedures
-
Cut all tie wraps on wiring harness using diagonal cutter.
-
Disconnect all wiring harness connectors to circuit board.
-
Remove bolts -2- (4x) at plastic cover -1- located above circuit board -3-.
-
Remove plastic cover -1-.
-
Remove bolt -4-.
-
Carefully remove circuit board.
Installing:
-
Carefully install circuit board so circuit board contacts seat correctly on contacts for switch located in side seat trim.
4
-
Bolt (1x)