A4 Quattro Sedan V6-2.8L (ACK) (1997)
Seat Back: Service and Repair
Backrest Motor With Transmission, Removing and Installing
WARNING!
Before starting work on seats, connect VAS5094 airbag adapter. See: Tools and Equipment/Electrical / Mechanical Repair
NOTE: Illustration only shows backrest.
1
-
Backrest frame
2
-
Backrest motor with transmission
Removing:
-
Move seat fully up.
-
Remove seat. See: Service and Repair
-
Remove trim panels. See: Service and Repair
-
Remove backrest upholstery.
-
Using screwdriver, remove spring washer -5- on backrest motor side (-B- in illustration).
-
Pull shaft out of backrest frame -1- far enough so backrest motor -2- can be removed.
-
Cut all tie wraps on backrest motor using diagonal cutter.
-
Disconnect harness connector -8-.
-
Unbolt mounting screw of backrest motor -5- from welded threaded bushing -6-.
-
Remove backrest motor -2-.
Installing:
-
Push shaft -3- through backrest motor -2- and backrest frame -1-.
-
Secure backrest motor -2- between two plastic washers -7- using mounting screw -5- on threaded bushing -6-.
-
Tap locking washer -4- onto shaft -3-.
3
-
Shaft
4
-
Locking washer
5
-
Mounting screw
6
-
Threaded bushing
7
-
Plastic washers (2x)
8
-
Harness connector