A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Remove nuts -1- attaching brake master cylinder to brake servo.
-
Carefully separate brake master cylinder from brake servo.
Note: Pay particular attention when installing:
-
Clean any spilled brake fluid from the plenum before installing brake servo and master cylinder.
-
When bolting the brake master cylinder to the brake seem make sure pushrod is correctly located in file master cylinder.
Installing
Note the points:
-
Adjust brake light switch.
-
Adjust vent valve for cruise control system .
Bleeding clutch hydraulics
-
Connect US1116 brake bleeder but do not switch on yet.
-
Open bleeder screw on clutch slave cylinder.
-
Attach collector bottle hose.
-
Switch on bleeder unit and allow approximately 100 cc (6 oz.) of brake fluid to flow out of clutch slave cylinder.
-
Close bleeder screw.
-
Bleed brake system.