A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Set 10-222A engine support bridge together with 10-222A/3 engine support adapter on fender mounting edges.
-
Attach 2024A engine sling to mounting eyes at front and rear of engine.
-
Using 10-222A engine support bridge spindle, lift up engine as far as possible.
-
Cut tie wraps (arrows), open bracket for starter wiring and remove wiring.
-
Remove torque support at front of engine.
-
Unbolt coolant line at front of engine from oil pan.
-
Disconnect harness connector from oil pressure switch on left-side of oil pan.
-
Disconnect coolant lines from oil cooler underneath oil filter.
-
Remove left and right nuts from lower engine mount -1-.
-
Mark installation positions for threaded assembly -1- and guide sleeves -2- on left and right lower engine mounts.
-
First remove front bolts -2- and -3- from left and right-sides of subframe. Then remove bolts -1-.
-
Swing stabilizer down.
-
Remove starter.
Note: Only loosen or lower subframe at front to avoid avoid changing wheel alignment.