A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Press buttons -0- and -6- to select "End Output" function 06, and press -Q- button to confirm input.
-
Switch off ignition.
Continuation
If no speed was indicated:
-
Connect VAG 1598/22 test box to ECM harness connector.
-
Connect VAG 1527B LED voltage tester between ECM/test box sockets 3 (B+) and 20 (signal).
-
Lift vehicle at left-front until wheel is free.
-
Switch ignition on and rotate left-front wheel by hand.
-
LED must blink (very brief blink)
NOTE:
-
The right-front wheel must not rotate; block it if necessary.
-
For LEDs with little voltage consumption, the LED lights up at half strength when the ignition is switched on.
If the LED does not blink:
-
Check wiring from ECM connector, terminal 20 to instrument cluster for open circuit or short circuit.
If the wiring is OK and the LED does not blink:
-
Check readiness code. If Diagnostic Trouble Code (DTC) memory has been erased, or ECM was disconnected, generate new readiness code.