A4 Quattro Sedan V6-2.8L (ACK) (1997)
Throttle Cable/Linkage: Adjustments
Accelerator Pedal Cable, Adjusting
Accelerator Pedal Cable, Adjusting
Accelerator pedal cable -1- connected to accelerator pedal and routed over the Throttle actuator control module cable quadrant.
-
Remove clip -3- from notched section of cable sleeve -4-.
-
Fully depress accelerator pedal to Wide Open Throttle position.
NOTE: Either use a second technician or a mechanical device to depress the accelerator pedal.
Vehicles with manual transmission
-
Move notched outer sleeve in or out of grommet -4- (as necessary) until Wide Open Throttle position is just reached.
-
Re-install clip -3- into the first completely exposed notch closest to the top of the grommet.
Vehicles with automatic transmission
-
Move outer sleeve in or out of grommet -4- (as necessary) until Wide Open Throttle position is just reached and the kick-down switch clicks
audibly.
-
Re-install clip -3- into the first completely exposed notch closest to the top of the grommet.
All vehicles
-
Release accelerator pedal (remove mechanical device, if used).
-
After adjusting, check the Closed and Wide open Throttle stops.
Vehicles with automatic transmission, adjustment checking
Test and auxiliary equipment required
-
Fluke 83 Multimeter
-
VW 1594 Adaptor kit
-
Disconnect 2-pin harness connector from kick-down switch
-
In engine compartment on firewall