A4 Quattro Sedan V6-2.8L (ACK) (1997)
/Page-3759001.png)
Air Bag Control Module: Service and Repair
Airbag Control Module -J234-, Removing And Installing
-
Disconnect battery Ground (GND) strap.
-
Remove front center console.
-
Disconnect securing bracket at harness connector -3-.
-
Disconnect harness connector -3- from control module -1-.
-
Remove nuts -2- (3x).
Tightening torque: 6 Nm (53 in. lb)
-
Remove airbag control module -J234-.
NOTE: If the airbag control module is replaced, the new control module must be coded. See: Testing and Inspection/Programming and Relearning
