A4 Quattro Sedan V6-2.8L (ACK) (1997)
-
Insert wiring harness
-
Attached with bolts for valve body
11. Transmission Vehicle Speed Sensor Retaining Bolt
-
Tighten to: 6 Nm (53 inch lbs)
-
Always replace
12. Transmission Vehicle Speed Sensor
-
Replacement, refer to "Transmission Vehicle Speed Sensor, Replacing", below
13. Inner oil line
-
Always replace after removing
-
Removing and installing, refer to "Inner Oil Line Removing and Installing", below
14. O-ring
-
Always replace
-
Coat with petroleum jelly
15. Spacer sleeve
-
Height: 8 mm
16. Speedometer Vehicle Speed Sensor
-
Replacing, refer to "Speedometer Vehicle Speed Sensor Removing and Installing", below
17. O-ring
-
Always replace
-
Coat with special grease
18. Multi-Function Transmission Range Switch
-
Replacement, Refer to "Multi-Function Transmission Range Switch, Replacing" below.
19. Multi-Function Transmission Range Switch Retaining Bolt
-
Tighten to: 8 Nm (70 inch lbs)
20. O-ring
-
Always replace
-
Coat with petroleum jelly
21. Locking clasp
-
For wiring harness connector
-
Ensure complete engagement when installing
22. Wiring harness
-
Transmission Fluid Temperature Sensor
-
Integrated in wiring harness
-
To replace, refer to "Valve Body Removing and Installing", below
-
Release from bracket for wiring harness, -item 10-
-
Location of wiring harness connector: flat point of rear shoulder faces down, the lugs on the shoulder are horizontal
23. Transmission Input Speed Sensor Retaining Bolt
-
Tighten to: 6 Nm (53 inch lbs)
24. Transmission Input Speed Sensor
-
Replacement, refer to "Transmission Input Speed Sensor Replacing", below.
25. Spacer sleeve
-
Height: 20 mm
26. Pressure Regulator Retaining Bracket Screw
-
Tighten to: 6 Nm (53 inch lbs)
27. Bracket for pressure regulator
28. Solenoid Valve 4
-
With O-ring
-
Apply a thin coat of petroleum jelly to O-ring before installing
-
To replace, refer to "Valve Body Removing and Installing", below
29. Solenoid Valve 3
-
Without O-ring
-
To replace, "Oil Pan Removing and Installing", below
30. Solenoid Valve 2
-
Without O-ring
-
To replace, refer to "Oil Pan Removing and Installing", below
31. Solenoid Retaining Bracket Screw
-
Tighten to: 6 Nm (53 inch lbs)
32. Bracket for solenoid valves
33. Solenoid Valve 6
-
With O-ring
-
Apply a thin coat of petroleum jelly to O-ring for installing
-
To replace, refer to "Oil Pan Removing and Installing", below
34. Solenoid Valve 7
-
With O-ring
-
Apply a thin coat of petroleum jelly to O-ring before installing
-
To replace, refer to "Oil Pan Removing and Installing", below