A4 Quattro Sedan V6-2.8L (ACK) (1997)
Drive/Propeller Shaft: Adjustments
01V Automatic Transmission
Driveshaft, Adjusting
-
Remove exhaust system.
-
Remove heat shield from above driveshaft.
-
Loosen securing bolts of the driveshaft at the body.
Note:
The following illustrations show a similar tool. Use tool 3405.
-
Install alignment fixture 3405 to driveshaft.
-
Remove securing bolts and shims.
-
Equalize the clearances -a- and measure.
-
Determine shim thickness from table.
Driveshaft, centering in lengthwise direction
-
Push driveshaft and alignment fixture 3405 fully rearward.
Note:
The illustration shows a similar tool. Use tool 3405.