audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Garage Door Opener Transmitter|Service and Repair > < Accessories - Can't Program Garage Door Opener|Page 8705
Page 2
background image

--

Service

1. Ask the customer to use another handheld transmitter or to replace the battery in his used handheld transmitter.

2. If the HomeLink system is using an alternate code, ask the customer to reset and resynchronize the HomeLink system. This will allow the receiver

transmitter's limited memory, which may be full, to be deleted. Information can be found in the owner's manual of the customer's HomeLink
system.

3. Some handheld transmitters stop transmitting a signal after 10 seconds. Ask the customer to press the button frequently during the programming

procedure.

4. If the vehicle is an A4 MY 2005 - 2006 or A3 MY 2009: J530 is installed on the left front side and not on the right front side as described in the

owner's manual. Inform the customer of the correct location of the garage door opener control module.

Warranty

This TSB is informational only and not applicable to any Audi warranty.

Additional Information

All parts and service references provided in this TSB are subject to change and/or removal. Always check with your Parts Department and service
manuals for the latest information.

Garage Door Opener Transmitter|Service and Repair > < Accessories - Can't Program Garage Door Opener|Page 8705