A4 Quattro Sedan V6-3.0L (AVK) (2002)
-
Remove seal using assembly wedge 3409.
Note: Ensure that the surface of the cylinder is not damaged during removal.
Installing
-
he surface of the piston and seal should be cleaned using only methylated spirits and then dried.
-
Thinly coat piston and seal with assembly paste G 052 150 A2 before inserting.
-
Insert the O-ring into the brake caliper housing
-
Place protective cap with the outer sealing lip on the piston.
-
Using assembly wedge 3409, insert the inner sealing lip into the groove on the cylinder.
Note: When doing this hold piston in front of brake caliper housing.