A4 Quattro Sedan V6-3.0L (AVK) (2002)
-
All:
-
Remove bolt - 2 - on belt module/belt tensioner - 1 - from luggage compartment from below.
-
Loosen bolt - 5 - on outer seat anchorage point (eyes on end of belt).
-
To disconnect harness connector - 7 -, open retainer using a screwdriver (USA).
-
Loosen cable with clip.
-
Installing:
-
When installing belt module - 1 -, ensure bolt - 2 - is in small diameter hole in retainer - 3 - both during and after tightening.
-
Ensure noise protection cap - 8 - on belt module - 1 - is seated correctly.
-
Ensure the belt tensioner wire - 4 - is clipped in and not in belt area.
-
Ensure connector - 7 - (USA) is engaged correctly.
-
Perform further installation in sequence opposite of removal.
2
-
Screw
-
Tightening torque 55 Nm
3
-
Belt module/belt tensioner locking holes
4
-
Belt tensioner cable with clip
5
-
Screw
-
Tightening torque 55 Nm
6
-
Seat belt
7
-
Belt tensioner connector
8
-
Noise protection cap