A4 Quattro Sedan V6-3.0L (AVK) (2002)
/Page-1327001.png)
Fluid Line/Hose: Service and Repair
ATF Lines, Removing and Installing (Overview)
Transmission, disassembling and assembling
-
Observe general repair instructions.
Rules of cleanliness for working on automatic transmissions
^
Thoroughly clean all connections and the surrounding area before disconnecting.
^
Place parts that have been removed on a clean surface and cover. Use foils and paper. Use lint-free cloths only!
^
Carefully cover over opened components or seal, if repairs are not carried out immediately.
^
Only install clean components: Only unpack replacement parts immediately prior to installation.
^
Always replace O-rings, gaskets and sealing rings.
^
Lightly lubricate O-rings before installing, this prevents the rings from being pinched when inserting.
^
Use only ATF in areas near ATF. Other lubricating substances cause functional problems in the hydraulic transmission control.
^
Check the following fluid levels after installing, top off if necessary. ATF in planetary gear, gear oil in front final drive, gear oil in center
differential. Capacities and specifications.
ATF lines, removing and installing (overview)
Special tools and equipment
^
VAG 1306 drip tray
Removing and installing ATF lines for 4 cylinder gasoline engines
Removing and installing ATF lines for 6 cylinder gasoline engines
ATF lines, removing and installing, (vehicles with 4 cyl. engine)
