A4 Quattro Sedan V6-3.0L (AVK) (2002)
Clutch Master Cylinder: Service and Repair
[01E] 6 Spd. M/T
Master cylinder, removing and installing - 6 Spd. Manual Transmission 01E
Special tools, testers and auxiliary items
^
Hose clamp 3094
Removing
-
If installed, remove cover above plenum chamber.
-
Disconnect battery Ground (GND) strap with the ignition switched off.
Remove E-Box from plenum chamber as follows:
-
Pull off clip -1- and lift wind grill - A - slightly. Now remove screw (arrow - 2 -).
-
Remove remaining screws (arrows) and remove cover.
-
Remove engine control unit and 8-point relay carrier (if fitted)
-
Unplug connector in connector station.
-
Pull engine wiring harness together with rubber grommet out through opening in electronics box.
-
Unscrew both nuts - A -.
-
Lift E-box off studs at the rear and then pull it out of securing point - B -.
Note:
^
In the following procedures, make sure that no brake fluid escapes into the plenum chamber or onto the transmission below. If this does
happen, clean the affected areas thoroughly.
^
When performing work in the footwell, put cloths on the carpet to protect it from possible brake fluid spills.