A4 Quattro Wagon L4-1.8L Turbo (AEB) (1999)
Impact Sensor: Service and Repair
Crash Sensor For Side Airbag, Removing And Installing
WARNING: Before starting work on seats, connect VAS 5094 airbag adapter.
NOTE:
-
A crash sensor for the side airbag is located under both the driver's and passenger's seats.
-
Both crash sensors for the side airbags are identical.
-
When installed, the arrow points down.
Removing:
-
Disconnect battery Ground (GND) strap.
-
Remove front seat.
-
Remove lower A-pillar trim.
-
Unclip sill molding and fold upward.
-
Pull up floor mat - 4 - near sensor.
-
Disconnect harness connector - 2 - from crash sensor for side airbag - 1 -.
-
Remove bolts - 3 - (2x).
Tightening torque: 6 Nm (53 in.lb)
-
Remove crash sensor for side airbag - 1 -.
Installing:
-
Switch ignition on.
-
Close doors.
WARNING: Make sure no one is in vehicle.
-
Connect battery Ground (GND) strap.