A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
^
Grease threaded head of 2085 seal puller, position and with forced pressure screw into oil seal as far as possible.
^
Loosen knurled bolt and turn inner part against crankshaft until oil seal is removed.
Installing
^
Lightly oil lip of oil seal.
^
Place guide sleeve from 3083 arbor on crankshaft.
^
Slide oil seal over guide sleeve.
^
Press in oil seal to stop together with pressure bushing and bolt from 3083 arbor.
^
Replace bolt for toothed belt gear.
^
Install toothed belt gear for crankshaft and secure using 3099 spur belt spreading.
Note:
^
Contact surface between toothed belt gear and crankshaft must be free of oil.
^
Do not grease crankshaft bolt for toothed belt gear.
^
Install toothed belt (adjust valve timing), Refer to Timing Belt, Service and Repair..
^
Place torque arm on rubber buffer for torque arm and tighten bolts to 25 Nm (18 ft. lbs.).
^
Install ribbed belt and ribbed belt tensioner.
Note: When installing the ribbed belt, make sure it is seated correctly on the pulley.