A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
Rear Knuckle: Service and Repair
Servicing
Rear Wheel Bearing Housing, Servicing
1. Wheel bearing housing
^
Do not grease bearing seat in wheel bearing housing before pressing in wheel bearing
^
After replacing, check and if necessary adjust wheel alignment
2. Clamping sleeve
^
Always replace
^
Left and right-sides identical
^
Grease all around with brake cylinder paste before inserting into wheel bearing housing
^
Press into wheel bearing housing until fully seated
3. ABS wheel speed sensor
^
To remove, pull out
^
Do not install until drive axle has been installed
^
To install, press in by hand until fully seated
4. Bonded rubber bushing
^
Replacing refer to Figs. 1, 2 and 3
^
Always replace both bushing halves
5. Wheel bearing
^
Stepped design
^
Installation position: larger inner diameter of wheel bearing faces wheel hub -7-
^
Removing refer to Fig. 4
^
Installing refer to Fig. 5
6. Splash shield
^
Bolt to wheel bearing housing
7. Wheel hub
^
Removing refer to Fig. 6
^
Installing refer to Fig. 7
^
Pressing off bearing inner race refer to Figs. 8 and 9
8. Bolt
^
10 Nm (7 ft. lbs.)
Fig. 1 Inserting assembly device into wheel bearing housing