A4 Quattro Wagon L4-1.8L Turbo (ATW) (2000)
Quarter Window Glass: Service and Repair
Undamaged Side Window (Avant), Removing
Undamaged Side Window (Avant), Removing
-
C/D pillar trim removed
-
Side trim removed
-
On vehicles with glass breakage sensors, harness connector must be disconnected at window to be removed and the window-side wire must be
secured on window (towards center) using adhesive tape.
CAUTION: If harness connectors are not disconnected, the wires will be cut during the cutting process and the window will be
destroyed.
-
Drill off rivet heads at C-pillar and knock out rivet shaft.
-
Remove C-pillar trim.
-
Drill off rivet heads - 1 - and knock out rivet shafts.
On vehicles with anodized trim strip, it should be removed.
-
Using handle - 1 -, stick needle - 2 - through adhesive bead.
-
Guide needle as close to glass as possible.
-
Remove handle and thread cutting cord through eye of needle.
-
Pull end of cutting cord - A - into interior (use pliers and gloves).