audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Pressure|Page 3949 > < Pressure|Page 3947
Page 3
background image

-

After 10 minutes, there must be at least 2.5 bar positive pressure

If residual pressure sinks below 2.5 bar positive pressure:

-

Start engine and let run at idle.

-

Wait until pressure has dropped, and then switch off ignition. Simultaneously close shut-off valve of VAG1318 pressure gauge (lever
perpendicular to direction of flow -arrow-).

-

Observe pressure drop on pressure gauge.

If pressure does not drop now:

-

Test check-valve on Fuel Pump (FP). 

If pressure drops again:

-

Open shut-off valve of pressure gauge. The lever points in the direction of flow.

-

Start engine and let run at idle.

-

Wait until pressure has dropped, and then switch off ignition. Simultaneously clamp return line (with blue marking) completely closed.

If pressure does not drop now:

-

Replace fuel pressure regulator

If pressure drops again:

-

Check wire connections, O-rings at fuel distributor and fuel injectors for proper seal.

-

Check whether pressure gauge is properly sealed.

NOTE:  Before disconnecting pressure gauge, release pressure by opening shut-off valve. Hold a container in front of connection for this.

Pressure|Page 3949 > < Pressure|Page 3947