A4 Quattro Wagon L4-1.8L Turbo (AWM) (2001)
Note: Apply assembly lubricant G 294 421 At before installing.
CAUTION: Part numbers are listed here for reference only. Always check with your Parts supplier for the test information.
3. Washer
-
Always replace
-
Ribbed side faces upward
4. Combi-bolt
-
Always replace
-
110 Nm (81 ft. lbs.) + 1/4 turn (90°)
Fig. 1 Pulling out front bonded rubber bushing from subframe
-
Assemble 3291/4 tubular section (pay attention to recesses) together with 3291 assembly device at right angle to subframe.
-
Attach two brass washers in such a way that annular grooves are next to one another (3291 assembly device). Install washer and screw on nut.
-
Pull out bonded rubber bushing by turning nut.
Note: Insert hex head of 3291 assembly device into the recess in the 3291/4 tubular section. Apply grease to the annular grooves of the brass
washers and to the threaded stem.
Fig. 2 Pressing in front bonded rubber bushing in subframe
-
Apply lubricant (e.g. G 294 421 A1) when pressing in bonded rubber bushings.
-
Assemble 3291/1 thrust piece to bonded rubber bushing and insert at right angle into hole in subframe using 3291/5 tubular section (pay attention
to recesses) and 3291 assembly device.
-
Attach two brass washers with annular grooves facing one another and to 3291 assembly device.
-
Install washer and screw on nut.
-
Press in bonded rubber bushing fully by turning nut.
-
While pulling in, hold 3291/1 thrust piece or bonded rubber bushing by hand to prevent turning.
Note: Insert hex head of 3291 assembly device into the recess of 329115 tubular section. Apply grease to the annular grooves of the brass
washers and to the assembly device.