audi Workshop Repair Guides

Audi Workshop Service and Repair Manuals

Scan Tool Testing and Procedures > < Performing Final Control Diagnosis|Page 9338
Page 2
background image

The following information will appear at bottom of display:

Do not press brake pedal again once test has been activated.

The Brake System Vacuum Pump V192 supplies vacuum to brake booster. The diagnosis of the brake booster system runs in the control module at the
same time.

The system passes the test if the pressure in the brake booster reaches the shut-off threshold within time limit set by diagnostic function.

The following information will appear at bottom of display:

-

You can cancel or exit from this mode by pressing Go to button.

The system fails the test if pressure in brake booster does not reach shut-off threshold within time limit set by diagnostic function.

The following information will appear at bottom of display:

Follow Guided Fault Finding procedure using vehicle diagnostic, testing and information system VAS 5051.

Scan Tool Testing and Procedures > < Performing Final Control Diagnosis|Page 9338