A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Crankshaft Main Bearing Seal: Service and Repair
Sealing flanges and flywheel/drive plate, removing and installing
Note:
^
Servicing clutch:
^
Observe clutch removal instructions
1. 15 Nm
2. Oil seal
^
Replace Crankshaft seal - ribbed belt side, replacing
^
Do not oil
3. Sealing flange, front
^
Must be located on dowel sleeves
^
To remove and install, remove oil pan
4. Cylinder block
^
Piston and connecting rod, disassembling and assembling
5. 60 Nm plus an additional 90° 1/4 turn
^
Replace
6. Dual-mass flywheel/drive plate
^
Dual-mass flywheel, removing and installing
^
Drive plate, removing and installing
^
Only possible to install in one position - Bores are offset
7. Intermediate plate
^
Must be located on dowel sleeves
^
Do not damage or bend when doing assembly work
^
Is hooked in at sealing flange