A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Power Distribution Module: Service and Repair
Vehicle Electrical System Control Module J519, Removing And Installing
NOTE: Should Vehicle Electrical System Control Module J519 require replacement, follow replacement procedures as specified using VAS 5051/5052
in mode "Guided Fault Finding".
Removing
CAUTION:
-
Switch off all electrical consumers.
-
Switch ignition off and remove ignition key.
-
Where applicable, remove drivers storage compartment.
-
Remove nuts - arrows - and remove Vehicle Electrical System Control Module J519 -1-.
-
Unclip fuse carriers -1... 3 -.
-
Release retaining clip at connector - 4 - and disconnect connector.
-
Disconnect electrical connections - 5 - and - 6 -.
Installing
Install in reverse order of removal, noting the following:
-
Install drivers storage compartment.
Tightening torque
Component - fastener
Nm
Control module to central tube
2.4
for instrument panel - nut