A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Brake Fluid Pressure Sensor/Switch: Service and Repair
Brake pressure sensor1 G201, removing and installing
Removing
Note: Protect engine compartment against escaping brake fluid.
-
Loosen securing bolt - 1 - and pull the coolant expansion tank out in direction of - arrow -, then swivel tank to one side.
-
Tightening torque: 6 Nm
-
Disconnect connectors - 1 -.
-
Unscrew brake pressure sensor - 4 -.
Installing
Remaining installation is in reverse sequence.
-
Bleed brake system.
-
Perform ESP road test VAS5051 vehicle diagnostic, testing and information system