A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Shift Cable: Adjustments
Selector Lever Cable, Checking and Adjusting
Selector lever cable, checking and adjusting, 09L, 6 Spd. A/T AWD
Special tools, testers and auxiliary items required
Socket and key T40031
Procedure
-
Remove selector mechanism cover.
-
Shift selector lever to position "S".
-
Insert socket and key T40031 through access hole in selector mechanism to loosen clamping bolt at rear of selector lever cable approximately 1
turn.
Note:
^
Only loosen clamping bolt 1 turn - do not remove.
^
Clamping bolt can only be accessed with selector lever in position "S".
^
The selector lever must remain in "S" position when clamping bolt is loosened, otherwise, adjustment will not be correct.
-
Carefully move selector lever slightly forward and backward, without shifting lever into a different selector lever position.
-
Pull selector lever once more to rear as far as possible into "S" position and release the selector lever.
Note:
^
Do not touch selector lever again during adjustment process.
-
Tighten clamping bolt in this position using socket and key T40031.
-
Install selector mechanism cover.
-
Check selector mechanism.