A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
6 - Clutch release lever
^
Removing go to Fig. 3
^
Must engage in lugs in intermediate piece when installed go to Fig. 4
^
Before installing, coat contact surface of clutch slave cylinder push rod with copper grease, e.g. Z 381 351 TE.
7 - Leaf spring
8 - Release and tighten bolt - 25 Nm
^
Self-locking
^
Always replace
9 - Release bearing
^
With or without plastic ring, depending on version go to Fig. 9
^
Cement detached plastic ring go to Fig. 9
^
Do not wash out, wipe clean only
^
Replace noisy bearings
^
Engage retaining latches at the release bearing in contact release lever