A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Pressure Plate: Service and Repair
Clutch, Servicing
Clutch, servicing, 01E, 6 Spd. M/T AWD
Special tools and equipment
^
Retainer 10-201
^
Thrust pad 3062
^
Centering mandrel 3176
^
Grease G 000 100
Notes:
^
Observe the general repair instructions.
^
The adjuster ring for the SAC-clutch pressure plate (self-adjusting clutch pressure plate) must be reset before assembly when the clutch ring is
replaced exclusively.
^
Replace clutch plates and pressure plates with damaged or loose rivets.
^
Select the correct clutch plate and pressure plate according to engine code:
^
Clean input shaft splines and (in the case of used clutch plates) the hub splines. Remove corrosion and apply only a very thin coating of grease G
000 100 to the splines. Then move clutch plate to and for on input shaft until hub moves freely on shaft. Excess grease must be removed.
^
Pressure plates are protected against corrosion and greased. Only the contact surface may be cleaned, otherwise the service life of the clutch will
be considerably reduced.
^
If the clutch has burnt out, thoroughly clean the bell housing, flywheel and parts of the engine facing the transmission in order to reduce the smell.