A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
/Page-2965002.png)
^
For correct version see Parts catalog
6 - Spacer (plastic)
^
Not installed on all versions
^
Installation position
^
For correct version see Parts catalog
7 - Snap ring
^
Always replace
^
Install into ring groove on shaft before installing (no longer visible once joint is installed)
8 - Outer CV joint
^
Replace as complete unit
^
Pressing off
^
Installing:
^
Use plastic hammer to pound joint onto shaft until snap ring snaps in.
^
Greasing
9 - Bolt
^
Always replace if removed
^
Loosening
^
Tightening
^
Tightening torque
10 - Clamp
^
Different versions for rubber or Hytrel boot Parts catalog
^
Always replace
11 - Boot for outer CV joint
^
Check for tears and chafing
^
To equalize pressure, briefly lift boot before tightening clamps
^
Different versions (rubber or Hytrel) Parts catalog
12 - Clamp
^
Always replace
13 - Drive axle
^
Different versions see Parts catalog
14 - Circlip
^
For correct version see Parts catalog
15 - Triple roller star
Chamfer - arrow - faces toward drive axle splines
16 - Circlip
^
Always replace
^
Insert in groove on shaft
17 - Socket-head bolt
^
For correct version see Parts catalog
18 - Joint body
Clamps on drive axle boots (rubber version) are tightened using hose clip pliers V.A.G 1275.
