A4 Quattro Wagon L4-2.0L Turbo (BPG) (2005)
Tightening clamp on inner joint
Removing outer CV joint from drive axle
-
Clamp drive axle in vise using jaw protectors.
-
Remove large clamp and pull back CV boot.
-
Using a hammer and a copper or brass drift, drive off inner ring of constant velocity joint.
Ventilating CV joint boot
Only applies to rubber CV boots
Note:
^
Installing the CV boot can create a vacuum in the joint. This vacuum pulls a fold inward when the vehicle is driven - arrow -. Therefore, before
tightening the clamp, raise the edge of the boot to allow the pressure to equalize.
Installation positions of spacer ring and dished washer (outer end of shaft)